SECTION 10—TOP SHROUD AND WHEELS
59
2. Place the top shroud on the base frame and push downward to engage the hook and
loop straps.
3. Secure the joystick cable using the clip on the top shroud.
4. Install the seat assembly. Refer to Removing/Installing the Seat Assembly on page 40.
5. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.
FIGURE 10.1
Removing/Installing the Top Shroud
Engaging/Disengaging Motor Release Lever
WARNING
DO NOT engage or disengage the motor release lever until the On/Off switch on
the joystick is in the Off position.
CAUTION
Ensure both motor release levers are fully engaged before driving the wheelchair
NOTE: For this procedure, refer to FIGURE 10.2.
NOTE: The motor lock disengagement/engagement allows freewheeling or joystick controlled
operation. Freewheeling allows an attendant to maneuver the wheelchair without power.
1. Locate the motor release handles on the motors protruding through the top shroud on
the rear of the wheelchair.
2. Perform one of the following:
• To Disengage the Motor Release Levers - Pull the motor lock lever towards the rear
of the wheelchair (freewheel position).
Top
Shroud
Front
Shroud
Base
Frame
Hook and
Loop
Strap
Hook and
Loop Strap
Joystick Cable
and Connector
Center
Hole in
Top
Shroud
NOTE: Batteries not
shown for clarity.
Clip
