Fixed-point landing
Square Pattern Manuever
Cross Pattern Manuever
Flip Forward
Flip Left
Flip Right
Flip Backward
N
O
Q
P
7
8
LEVEL SURFACE CALIBRATION
If the aircraft becomes unstable during the
course of flying, you may need to restabilize the
internal gyros.
To do this, Turn Off the controller and disconnect
the Drone battery. Place the ORBIT™ HD on a flat
level surface. Follow the steps to sync your ORBIT
™ HD (page 4). Now, pull both the joysticks
downwards and towards the right at the same
time(see diagram N). The lights on the drone will
flash a bit and then remain solid. This indicates
that your drone has been calibrated.
FLYING ENVIRONMENT
The ORBIT™ HD is designed for outdoor use only. When flying, do so in warm sunny weather with no wind or
rain.
WARNING:
Do not fly in extreme temperatures or windy conditions as this may affect the performance of
your ORBIT™ HD and cause damage or injury.
FLIGHT PRACTICE
To master flying your aircraft try practicing the exercises shown below. Start with simple vertical takeoffs,
landings, and left/right turning and rotating. Once those are mastered move on to square and cross
maneuvers. Good luck and have fun!
PERFORMING 360º FLIPS
After you have mastered flying the ORBIT™ HD you are ready to try flips. Once the ORBIT™ HD is hovering
at least 3 meters (about 10 feet) off the ground, trigger the 360º Flip Button (see diagram O) and push the
right lever forward slightly and let go. The ORBIT™ HD will instantly perform a forward flip. To perform a
backwards or side flip press and hold the 360º Flip Button and push the right lever in the direction you wish
to flip just as you did for the forward flip (see diagram P & Q).
TROUBLESHOOTING YOUR ORBIT™ HD
PROBLEM
POSSIBLE REASON
SOLUTION
No Power
1. Power switched off
2. Polarity is reversed
3. Batteries may be dead
1. Switch the ON/OFF switch to ON
2. Make sure all batteries are installed
correctly (see diagram B)
3. Replace batteries
Remote Not
properly
Responding
Aircraft Won’t
lift off
Aircraft
Descends
Too Fast
Aircraft Not
Responding
Loss of
ORBIT™ HD
Control
1. Remote is switched off
2. ORBIT™ HD battery is not connected
3. Too windy
4. The remote is not synced
1. Switch the ON/OFF switch to ON
2. Connect the battery to ORBIT™ HD
3. Windy conditions severely impair the
operation of the ORBIT™ HD
4. Re-sync the remote
1. Rotor speed too slow
2. Aircraft not fully charged
1. Push throttle lever forward
2. Recharge your ORBIT™ HD
1. Moving the throttle too quickly
1. Control the throttle slower and
smoother
1. Gyroscopes not functioning
1. Turn ON the ORBIT™ HD and
Reset the Gyros (see diagram P)
1. Aircraft is out of range of remote
1. Keep the aircraft within a 300
feet radius of the remote
