ON
ON
ON
Fixed-point landing
Square Pattern Manuever
Cross Pattern Manuever
N
O
P
7
8
CALIBRATING THE SKY MASTER™
NOTE: Your Sky Master™ comes pre-calibrated out of the box
so you are ready to fly.
After several crashes and shock to your gyro sensors, you may
notice that your drone is drifting and not holding its center
position as well as it used to.
This most likely means that you need to recalibrate the 6 axis
gyro. Please follow the simple instructions below.
1. Gently set your Sky Master™ on the flat surface.
2. Make sure the Sky Master™ is on and that the controller is
synced (refer to syncing pg 4. ). Do not start the blades.
Instead move both the throttle and control stick down and to
the left corner and hold them there for 5 seconds(See
Diagram N). You will see the lights on the drone rapidly flash and stop. Once the lights stop flashing you
have completed your calibration and are ready to fly!
TROUBLE SHOOTING
: If you do not see the lights flash, turn off your controller take out the battery in the
Drone and Start again. Always make sure to put your battery in first, then turn on your controller. Push the
left throttle stick up all the way and then pull back down again. When you hear the beep the Sky Master™
is synced to the controller and you are ready to calibrate.
FLIGHT PRACTICE
To master flying your aircraft try practicing the excersizes shown below. Start with simple vertical takeoffs,
landings, and left/right turning and rotating. Once those are mastered move on to square and cross
maneuvers. Good luck and have fun!
HOW TO PERFORM 360º STUNT ROLLS
Performing 360º stunt rolls with the Sky Master™ is as easy as 1-2-3:
1. Hover the Sky Master™ in still position making sure that you have at least 5 feet of clearance above
and below the quadrocopter,.
2. Press and release the 360˚ stunt button and you will enter the stunt roll mode which is indicated by a
rapid beeping (see diagram O).
3. Determine which direction you want it to flip and quickly push the right control stick in the direction
you want to flip your Cloud Force (see diagram P).
You have 4 choices a) Forward Roll, b) Backwards roll, c) Right side roll, d) Left side roll.
SPEED SELECT BUTTON
The Sky Master™ has 4 speed settings; 40%,60%,80% and 100%. The Default setting when you first turn
on your Sky Master™ is the 40% speed mode. To increase the speed simply press the Speed button (see
remote diagram on pg 3) you will hear 1 beep and the speed changed to higher level speed, the current
speed will continously flashing on the LCD screeb. Speed settings can be set before flight or during the flight.
HEADLESS MODE BUTTON
You can maintain orientation of your Sky Master™ during flight.
1. Once the Sky Master™ is activated press the headless mode button (see controller on pg.3) to activate
the internal compass.
2. The flying orientation is now locked to match the direction control lever.
