9
10
360˚Stunt Roll Button
V2
V1
U
T
S
HOW TO PERFORM 360º STUNT ROLLS
Performing 360º stunt rolls with the ALTITUDE 2.0 Quadrocopter is as easy as 1-2-3:
1. Hover the ALTITUDE 2.0 in still position making sure that you have at least 5 feet of clearance above
and below the quadrocopter, Set the speed settings to 70% or 100%.
2. Press down and hold the 360 stunt button for 1.5 seconds and you will enter the stunt roll mode which is
indicated by a rapid beeping (see diagram V1).
3. Determine which direction you want it to flip and quickly push the right control stick in the direction
you want to flip your Altitude 2.0 drone (see diagram V2).
You have 4 choices a) Forward Roll, b) Backwards roll, c) Right side roll, d) Left side roll.
4. To exit the Stunt Roll mode, simply release the button.
CALIBRATING THE ALTITUDE 2.0
NOTE: Your ALTITUDE 2.0 comes pre-calibrated out of the box so you are ready to fly.
After several crashes and shock to your gyro sensors, you may notice that your drone is drifting and not
holding its center position as well as it used to.
This most likely means that you need to recalibrate the 6 axis gyro. Please follow the simple instructions
below.
1. Using the included Calibration Table: Place the calibration table on the ground or any other stable surface.
2. Adjust the four screws making them longer or shorter until your water level air bubble is perfectly
balanced in the center ring. (See Diagram S).
3. Gently set your ALTITUDE 2.0 drone on the cross sections of the calibration table: (See Diagram T).
4. Make sure the ALTITUDE 2.0 is on and that the controller is synced (refer to syncing pg 4. ). Do not start
the blades. Instead move both the throttle and control stick down and to the left corner and hold them
there for 5 seconds(See Diagram U). You will see the lights on the drone rapidly flash and stop. Once the
lights stop flashing you have completed your calibration and are ready to fly!
TROUBLE SHOOTING
: If you do not see the lights flash, turn off your controller take out the battery in the
Drone and Start again. Always make sure to put your battery in first, then turn on your controller. Push the
left throttle stick up all the way and then pull back down again. When you hear the beep the ALTITUDE
Drone is synced to the controller and you are ready to calibrate.
IMPORTANT TIP: WHEN USING YOUR CALIBRATION TABLE IT WILL WORK BEST IF YOU START WITH THE
SCREWS HALF-WAY THROUGH THE SCREW HOLES. STARTING WITH THE SCREWS ALL THE WAY THROUGH
THE HOLES MAY MAKE IT DIFFICULT TO PROPERLY LEVEL THE TABLE
IMPORTANT NOTE: YOU MUST DEPRESS HOLD DOWN THE STUNT BUTTON UNTIL YOU BEGIN TO FLIP.
