background image

Made in China

CHOKING HAZARD - Small parts. 

Not suitable for children under 3 years.

WARNING!

INSTRUCTION BOOKLET

Colors and styles may vary slightly.

PACKAGE CONTAINS:

2.4G Wireless Controller

Instruction Manual

Spare Parts

USB Card Reader

USB Charger

&  Li-Poly 

Rechargeable Battery

WARNING: Never leave product charging unattended for extended periods of 

time. Always disconnect Cloud Rider™ HD 2.0 battery from charger immedi-

ately after it is fully charged. Please refer to enclosed safety instructions.

Cloud Rider™ HD 2.0

V 1.0

Requires Speed Class 6 or higher microSD or 

microSDHC card (included)

microSDHC Logo is a trademark of SD-3C, LLC.

Conforms to safety requirements of RTTE, RSS210 and FCC.

8619 Wall street, Suite 400, Austin, TX 78754

©2017 Rooftop Brands™    All rights reserved 

Tel: 

1-866-458-5151

 •  www.propelrc.com

  

FCC Part 15 C Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the 
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures:
•    Reorient or relocate the receiving antenna.
•    Increase the separation between the equipment and receiver.
•    Connect the equipment into an outlet on a circuit different from that to which the receiver is 
      connected.
•    Consult the dealer or experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : 
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

INDUSTRY CANADA NOTICE: CANADA ONLY.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not 
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux 
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter dout brouillage radioélectrique subi, 
même si le brouillage est susceptible d'en compromettre le fonctionnement.

WEEE Directive & Product Disposal
At the end of its serviceable life, this product should not be treated as household or general waste. It should be 
handed over to the applicable collection point for the recycling of electrical and electronics equipment, or 
returned to the supplier for disposal.
Internal/Supplied Batteries
This symbol on the battery indicates that the battery is to be collected separately. This battery is designed for 
separate collection at an appropriate collection point.

IMPORTANT! REGISTER YOU DRONE

The U.S. Department of Transportation’s Federal Aviation Administration (FAA) announced a streamlined and 

user-friendly web-based aircraft registration process for owners of small unmanned aircraft (UAS) weighing 

more than 0.55 pounds (250 grams) and less than 55 pounds (approx. 25 kilograms) including payloads such 

as on-board cameras.

Owners can get more info and may register through a web-based system at www.faa.gov/uas/registration

2.4GHz Quadrocopter with Live Video Streaming

and Altitude Stabilization Technology

CLOUD RIDER HD 2.0

ON BOARD

HD VIDEO

ON BOARD

HD CAMERA

1280 x 720 pixel 

30 frames per second

ARTWORK NO.

DESCRIPTION

MDSER

DESIGNER

DATE

C59-Cloud Master IM

114.3×174.6mm

Bobby

Cocoa

2017/5/8

Summary of Contents for CLOUD RIDER HD 2.0








Reviews: