9
10
Fixed-point landing
Square Pattern Manuever
Cross Pattern Manuever
Flip Forward
Flip Left
Flip Right
Flip Backward
N
O
Q
P
LEVEL SURFACE CALIBRATION
If the aircraft becomes unstable during flight, you
may need to restabilize the internal gyros.
To do this, Turn Off the controller and disconnect the
Drone battery. Place the Cloud Rider™ HD 2.0 on a
flat level surface. Follow the steps to sync your Cloud
Rider™ HD 2.0 (page 4). Now, pull both the joysticks
downwards and towards the right at the same
time(see diagram N). The lights on the drone will
flash a bit and then remain solid. This indicates that
your drone has been calibrated.
FLYING ENVIRONMENT
The Cloud Rider™ HD 2.0 is designed for outdoor use only. Pick a day of warm sunny weather with no wind or
rain.
WARNING:
Do not fly in extreme temperatures or windy conditions as this may affect the performance of
your Cloud Rider™ HD 2.0 and cause damage or injury.
FLIGHT PRACTICE
To master flying your aircraft try practicing the exercises shown below. Start with simple vertical takeoffs,
landings, and left/right turning and rotating. Once those are mastered move on to square and cross
maneuvers. Good luck and have fun!
PERFORMING 360º FLIPS
After you have mastered flying the Cloud Rider™ HD 2.0 you are ready to try flips. Once the Cloud Rider™
HD 2.0 is hovering at least 3 meters (about 10 feet) off the ground, trigger the 360º Flip Button (see
diagram O) and push the right lever forward slightly and let go. The Cloud Rider™ HD 2.0 will instantly
perform a forward flip. To perform a backwards or side flip, trigger the 360º Flip Button and push the right
lever in the direction you wish to flip just as you did for the forward flip (see diagram P & Q).
TROUBLESHOOTING YOUR CLOUD RIDER™ HD 2.0
PROBLEM
POSSIBLE REASON
SOLUTION
No Power
1. Power switched off
2. Polarity is reversed
3. Batteries may be dead
1. Switch the ON/OFF switch to ON
2. Make sure all batteries are installed
correctly (see diagram B)
3. Replace batteries
Remote Not
properly
Responding
Aircraft Won’t
lift off
Aircraft
Descends
Too Fast
Aircraft Not
Responding
Loss of
Cloud Rider™ HD 2.0
Control
1. Remote is switched off
2. Cloud Rider™ HD 2.0 battery is not connected
3. Too windy
4. The remote is not synced
1. Switch the ON/OFF switch to ON
2. Connect the battery to Cloud Rider™ HD 2.0
3. Windy conditions severely impair the
operation of the Cloud Rider™ HD 2.0
4. Re-sync the remote
1. Rotor speed too slow
2. Aircraft not fully charged
1. Push throttle lever forward
2. Recharge your Cloud Rider™ HD 2.0
1. Moving the throttle too quickly
1. Control the throttle slower and
smoother
1. Gyroscope not functioning
1. Turn ON the Cloud Rider™ HD 2.0 and
Reset the Gyro (see diagram P)
1. Aircraft is out of range of remote
1. Keep the aircraft within a 350
feet radius of the remote
