background image

Cloud Rider

TM

Made in China

Conforms to safety requirements of ASTM, CPSIA and FCC. 
©2016 Rooftop Brands™    All rights reserved 

Tel: + (1) 949-566-9573  •  www.propelrc.com

 

FCC Part 15 B Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
•    Reorient or relocate the receiving antenna.
•    Increase the separation between the equipment and receiver.
•    Connect the equipment into an outlet on a circuit different from that to which the receiver is 
      connected.
•    Consult the dealer or experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : 
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired 
operation.

CHOKING HAZARD - Small parts. 

Not suitable for children under 3 years.

WARNING!

WARNING: Never leave product charging unattended for extended periods of 

time. Always disconnect Cloud Rider

TM

 battery from charger immediately after 

it is fully charged. Please refer to enclosed safety instructions.

INSTRUCTION BOOKLET

Colors and styles may slightly vary.

PACKAGE CONTAINS:

2.4G Wireless Controller

Instruction Manual

Spare Parts

AC Charger

Cloud Rider

TM

 Drone

2.4GHz Quadrocopter With Camera

INDUSTRY CANADA NOTICE: CANADA ONLY.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: 
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause 
undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est 
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit 
accepter dout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Summary of Contents for Cloud Rider







Reviews: