Propeller Blade
Li-Poly Battery Compartment
CLOUD RIDER™ QUADROCOPTER DIAGRAM
CLOUD RIDER™ REMOTE DIAGRAM
CLOUD RIDER™ REMOTE LCD DIAGRAM
Video Button
Throttle Trim
Adjustment
Throttle & Spin
Left/Right
Right/Left Spin
Trim Adjustment
Power Switch
Power Indicator
Antenna
360º Flip Button
Forward/Backward
Bank Left/Right
Forward/Backward
Trim Adjustment
Bank Right/Left Trim
Adjustment
100% Speed
Light On/Off
Photo
40% Speed
60% Speed
80% Speed
LED Screen
D
3
4
FLIGHT PREPARATION
• Verify that there are 6 “AA” batteries inside the remote control unit and the Cloud Rider™ has been
fully charged.
• Make sure your Cloud Rider™ and controller are both turned on.
• Make sure to be in a large space with an open radius of at least 200 feet.
• Make sure the empty space has no obstacles. Set your Cloud Rider™ on a clean flat surface before take-off.
DO NOT ATTEMPT TO FLY YOUR CLOUD RIDER™ IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR
LIGHTNING OUTDOORS. IT COULD DAMAGE YOUR PRODUCT AND POSSIBLY EVEN CAUSE BODILY HARM.
SYNCING YOUR CLOUD RIDER™
Important! When syncing your Cloud Rider™ quadrocopter with the controller always make sure
that the quadrocopter is on a flat level surface and that your digital trim settings are in the center
position. This insures that the 6 Axis gyro is properly programmed to mimic your trim settings.
Your Cloud Rider™ utilizes an automatic 2.4G channel selection system that allows up to 8 people to fly
side by side in the same wireless range with no interference.
Syncing your aircraft:
1. Before starting, make sure that the power on your controller is in the OFF position and the Cloud Rider™
wire leads are not connected. Make sure that there are no other 2.4Ghz devices in the area as well .
2. Open the battery compartment. Connect the battery wire lead to the Cloud Rider™ and set it down
on a flat surface. The LED indicator lights of the Cloud Rider™ should begin to flash (see diagram D).
Insert battery and close compartment.
3. Next turn ON the remote controller. After hearing a series of beeps, the Cloud Rider's
TM
flashing LED
lights will change to a solid glow signaling that the drone and controller have been synced. If this
does not happen, repeat all steps above.
FLYING TIPS
• It is recommended that you operate the Cloud Rider™ outdoors in a wide space. The ideal space should
have a 200 foot radius.
• Parental guidance or adult supervision is suggested at all times.
• If you are flying the Cloud Rider™ with others, make sure all spectators are behind you.
• For best performance, it is recommended that you operate the Cloud Rider™ in zero wind conditions.
Wind can greatly affect the performance of the aircraft or cause injury.
DO NOT FLY YOUR CLOUD RIDER™ IN FOUL WEATHER!
WARNING
Throttle Speed Trim
Rotate Left/Right Trim
Battery Capacity
Forward/Backward
Trim
Bank Left/Right
Trim
Speed Indicator
CLOUD
RIDER
