Fixed-point landing
Square Pattern Manuever
Cross Pattern Manuever
Flip Forward
Flip Left
Flip Right
Flip Backward
O
Q
P
7
8
FLIGHT PRACTICE
To master flying your aircraft try practicing the excersizes shown below. Start with simple vertical takeoffs,
landings, and left/right turning and rotating. Once those are mastered move on to square and cross
maneuvers. Good luck and have fun!
PERFORMING 360º FLIPS
After you have mastered flying the Cloud Rider™ you are ready to try flips. Once the Cloud Rider™ is
hovering at least 3 meters (about 10 feet) off the ground, trigger the 360º Flip Button (see diagram O) and
push the right lever forward slightly and let go. The Cloud Rider™ will instantly perform a forward flip. To
perform a backwards or side flip press and hold the 360º Flip Button and push the right lever in the
direction you wish to flip just as you did for the forward flip (see diagram P & Q).
PROBLEM
POSSIBLE REASON
SOLUTION
1. Power switched off
1. Switch the ON/OFF switch to ON
No Power
2. Polarity is reversed
2. Make sure all batteries are installed
correctly (see diagram B)
3. Batteries may be dead
3. Replace batteries
1. Remote is switched off
1. Switch the ON/OFF switch to ON
Remote Not
2. Cloud Rider™ battery is not connected
2. Connect the battery to Cloud Rider™ properly
Responding
3. Too windy
3. Windy conditions severely impair the
operation of the Cloud Rider™
4. The remote is not synced
4. Re-sync the remote
Aircraft Won’t
1. Rotor speed too slow
1. Push throttle lever forward
lift off
2. Aircraft not fully charged
2. Recharge your Cloud Rider™
Aircraft
Descends
1. Moving the throttle too quickly
1. Control the throttle slower and
Too Fast
smoother
Aircraft Not
1. Gyroscopes not functioning
1. Turn ON the Cloud Rider™ and
Responding
Reset the Gyros (see diagram P)
Loss of
Cloud Rider™
1. Aircraft is out of range of remote
1. Keep the aircraft within a 300
Control
feet radius of the remote
TROUBLESHOOTING YOUR CLOUD RIDER™
Ra
Sa
Sb
Rb
Adjust Lens Angle
LOCK 1
LOCK 2
Snap Camera Into Position
ATTACHING THE OPTIONAL CAMERA
You have the option of attaching the optional camera with precision to your Cloud Rider™ quadrocopter.
1. Install the camera on the under side of the Cloud Rider™ by sliding the camera forward into position
and adjust lens angle (see diagram Ra & Rb).
2. Connect the camera lead to the Cloud Rider™ in the appropriate connection plug (see diagrams Sa & Sb).
Consult your retailer for additional attachable devices
Snap camera legs
Into the two locks
on the belly of cloud riderTM
