23
on/off
lasers
2
beeP
1 seconds
4 seconds
on/off
white leds
1
beeP
_____________
_____________
r
ed
-s
ynCed
to
s
hiP
b
lUe
-
synC
to
Phone
(
with
or
withoUt
beinG
synCed
to
P
hone
)
speed change
speed 1
speed 3
speed 2
t-mode
turn on/oFF led’s and lasers
when the controller is powered on, it will always
start on speed 1. if the controller was in speed
mode 3 before turning it off, it will return to speed
mode 1 when it is turned back on.
push the button to change speeds between modes
1-3. if you are in speed mode 3 and press the
button, you will cycle over to speed mode 1.
flying speed is indicated by the leds surrounding
the controller’s power button.
push the button for 1 second (you will hear
1 beep) to turn on/off the white leds that
illuminate your ship. (the red leds in the rear of
your ship will remain on.)
hold down the button for 4 seconds (you will
hear 2 beeps) to turn on/off your ship’s lasers.
note that when the lasers are activated, the ir
transceiver will be deactivated, and vice versa.
simultaneously push the left and right gimbals
(control sticks) down and in to activate the
emergency stop. this will cut all power to the
motors and the ship will fall to the ground. this is
only to be used in case of emergency, as the ship
may get damaged when it hits the ground.
emergency stop
Summary of Contents for T-65 X-Wing
