V4.0
250 LB LADDER RACK
8819435
Visit www.princessauto.com for more information
9
COMPLETE INSTALLATION
1. Insert an upright (#3) into each bracket until seated. The
upright with the ladder stop (#5) goes into the rear
bracket.
2. Screw an M10x15 Allen head set screw (#10) into the bolt
hole of the front and rear upright supports (#6). Screw the
last two set screws into the Front and rear bracket.
3. Insert the adjustable arm (#8) into the horizontal cross
piece (#7). Adjust the arm length by pulling it out of the
cross arm. Leave a minimum of 2-1/2 in. in the cross arm.
The arm is held in place by friction.
4. Tighten all bolts, nuts and screws.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical
replacement parts when servicing.
3. Maintain the tool’s labels and name plates. These carry
important information. If unreadable or missing, contact
Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
