8819450
CONTRACTOR TRUCK RACK
V1.0
8
For technical questions call 1-800-665-8685
2. Move the rack forward or backwards to adjust the rack’s
position to center each set of feet on the rim.
3. Insert two J-hooks (#9) through the bottom of each foot’s
attachment points so the bar end is under the rim. Secure
each hook with an M12 washer and nut set (#23).
4. Push the hook upward until the bar end contacts the rim.
Tighten the nut to almost secure the rack.
5. Repeat steps 3 and 4 with all hooks and feet.
6. Make any last minute position adjustments, then tighten the
J-hook nuts with a wrench to secure the rack.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical
replacement parts when servicing.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
