Ball Mount 3 Bike Carrier
FGAT1100-1 Instructions
1B. Mounting the Bike Carrier on Ball Mount
Rotate the saddles as shown.
1C. Mounting the Bike Carrier on Ball Mount
Package Contents:
3 Bike Carrier
Carriage Bolt
Washer
Locking Knob with key
Remove safety pin, squeeze handle and bring uprights together.
Note: Spacing Guideline
1D. Mounting the Bike Carrier on Ball Mount
Ball mount must be inserted into receiver and have a minimum of
2 -1/2 inches from the rear of the vehicle to the ball mount drop.
Position the clamp jaws over the ball mount.
1A. Mounting the Bike Carrier on Ball Mount
1E. Mounting the Bike Carrier on Ball Mount
Squeeze handle and push down
on center of handle until handle
locks into place.
Reinstall the safety pin in the
handle.
Rotate the saddles back to the
upright position.
Fold the arms out to the 90° stopped position as shown above.
ProRac Systems Inc. Toll Free: 1-800-217-7133
7109 31
st
Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
WWW.PRORAC.COM
