18
19
Turning On the Device
1. Press and hold the ON+ button for two (2) seconds to turn on
the device.
2. The most recently selected treatment time and program will
flash when the unit is turned on.
Note : Do not turn the unit on until all electrodes and lead
wires are properly attached.
Note : When stimulating the muscles of the arms or legs bear
in mind that the muscle contraction may cause involuntary
limb movement which could cause injury to you or others.
Always ensure the limb is secured to prevent movement.
Turning Off the Device
1. The device turns off automatically after the therapy session
time has elapsed.
2. To turn the unit off manually, press the OFF- button for three
(3) seconds. The display will blank and the device will turn off.
3. In an emergency you may also pull the connector(s) from the
device and then remove the belt.
Note : To prevent unpleasant electric shocks, never remove
the device while it is still turned on.
Selecting the Treatment Time
1. Press MODE. The preset (default) treatment time will flash on the display.
2. To increase or decrease the treatment time, press the button ON + (to
increase) or the button OFF – (to decrease) repeatedly until the desired
duration appears on the display.
3. Press MODE again to save your selection. The treatment time you selected
will appear on the display the next time you turn the device on.
Note : If you change programs during the course of a therapy session,
the treatment time will not reset unless you manually reset it
by performing the steps described above.
Program
Pulse width(uS)
Pulse rate(Hz)
Function Mode
P1
260
15
Constant
P2
260
60
Burst
P3
260
60
Constant
P4
260~156
2~60
Modulation
P5
260~156
60
Modulation
P6
260
7~60
Modulation
P7
260~156
60
Modulation
P8
P1~P7
Cycle
Selecting the Program (TENS)
The Device offers 16 different pre-set treatment programs respectively for TENS/
EMS modes ; the programs differ with respect to varying pulse widths and fre-
quencies.
For TENS programs:
When using any of the 8 programs for pain relief always start with the lowest inten-
sity and gradually increase the level of intensity until you feel a “tingling” sensation.
All programs are different and therefore feel differently. You may try all 8 programs
in the beginning and choose one that feels pleasant. Never increase the intensity to
a level so that it hurts, always stay under the point of discomfort. Start with short
sessions of 5 or 10 minutes until your body gets used to the stimulation.
1. Press MODE after treatment time is set. The preset (default)
therapy mode TENS/EMS will flash on the display. Use ON +
(to increase) or the button OFF – (to decrease), if you would
like to change the therapy mode.
2. Press Mode again, the numeric number of program is then
flashing. Press the button ON + (to increase) or the button
OFF – (to decrease) for choice of program of the selected
modality.
3. Press MODE again to save your selection. The treatment
time you selected will appear on the display the next time
you turn the device on.
Note : If you change programs during the course of a therapy
session, the treatment time will not reset unless you manually
reset it by performing the steps described above.
