– 22 –
– 23 –
5 Usually, low speed is for finger or toe nails. High speed is for thick corn or
dead skin.
6 The two buttons marked with (+) and (-) allow you to select the speed of
rotation. (+) button is increasing the rotation speed; (-) button is reducing
the rotation speed.
7 When the front bright light has flashed twice in the speed selection, it is
indicated the speed selection has reached the lowest speed level or the
highest speed level. The rotation speed will maintain at the same speed rate
no further up or down.
8 The device can memorize the last speed setting and rotation direction for
the next use. It will auto reset when charging.
9 When the battery power is low up to the corresponding LED will blink to
remind you to recharge the device. It needs 4 hours to have full charged.
10 When battery power is empty, the corresponding LED will continue to blink
for 5 seconds and the device will automatically switch off. It needs to be
charged for 30minutes before it can be used again.
Tips : For better performance and results, do not wash your hands or feet
before treatment. Wash after treatment and massage in a moisturizer to
soothe your skin.
The device switches off automatically after 20 minutes. After
this time, have a break of at least 15 minutes to prevent the
motor from overheating.
The device switches off if an attachment is prevented from moving for
approx. 3 seconds during use. To restart the device, switch it briefly off
and then on again.
