20
21
Press MODE after treatment mode is set.
1. To choose Program (P1~P8), use Up + (to increase) or the button Down – (to
decrease).
2. Program P9, it is self –programmable mode. To set up desirable pulse width
between 50~260uS and frequency at 2~60Hz (for TENS) and 7~70Hz (for EMS) :
2.1. Press Mode button, the preset (default) Pulse Width is then flashing.
Press the button Up + (to increase) or the button Down – (to decrease) for choice
of the selected Pulse Width .
2.2. Press Mode button again, the preset (default) Pulse Rate is then flashing.
Press the button Up + (to increase) or the button Down – (to decrease) for
choice of the selected Pulse frequency.
3. Press MODE again to save your selection. The treatment program you selected
will appear on the display the next time you turn the device on.
➠
➠
➠
➠
Selecting the Treatment Time
1. Press MODE. The preset (default) treatment time will flash on the display.
2. To increase or decrease the treatment time, press the button ON + (to increase)
or the button OFF – (to decrease) repeatedly until the desired duration appears
on the display.
3. Press MODE again to save your selection. The treatment time you selected will
appear on the display the next time you turn the device on.
Note:
If you change programs during the course of a therapy session,
the treatment time will not reset unless you manually reset it by performing
the steps described above.
Selecting the Therapy Intensity Level
This device offer a maximum of 25 intensity levels.
The intensity of the electrical current determines the number of working fibers in
the stimulated muscles. The lower the current intensity the lower the number of
working fibers in the muscle. The higher the current intensity the greater the num-
ber of working fibers in the muscle.
If using the device for help with temporary relief of pain associated with sore and
ching muscles then you will find that setting the current intensity to your own com-
fortable and pleasing level will give you much satisfaction. This level is different for
each user so adjusts slowly and accordingly.
If you desire to stimulate healthy muscles (EMS) in order to improve and facilitate
muscle performance then you want to achieve a significant number of working
fibers. You require a minimum intensity (approx. 30mA) to accomplish this .
This can be achieved relatively quickly (2 to 3 sessions) by progressively increasing
the intensity during the session. Once this threshold is reached, continue to pro-
gressively increase the current intensity making the session more effective.
➠
➠
