50M
奔 馳 距 離 可 達
以上
當壓力表指針指到紅色區域時,安全氣閥裝置會自動開啟來排放多餘的空氣。
一 推 就 跑
42
1.
轉動後輪(如下圖),以便將空氣完全釋放。
3.
請依照下圖指示打氣
1
3
2
開始時,請快速打氣至少
20
次
(為了良好的遊玩效果,請持續打氣直到壓力表指針指到紅色區域)
2. 轉動後輪讓圓形凸輪上
˝
˝
標記對正車架右側凸起之一字造形處
(如下圖所示位置),開始打氣。
50M
Distance
up to
PUSH TO GO
PUSH TO GO
A safety device is equipped, excessive air will be released automatically once pressure meter measured
and pointed to the red range.
遊 戲 方 式
How To Play
Spin the rear wheel (as below)to release
air completely.
Pumping as below figures .
(To obtain the best results, do not stop pumping until pressure meter measured and pointed to the red range.)
Rotate the rear wheel and have the ˝ ˝ align to the protrusion
bar (as below),then start to pump.
In the beginning, pump up 20 times at least to start.
If pressure meter can not gauge to red range, or air leaks from uncertain somewhere.
Check if air tubes are installed correctly. ( Below marked positions to help you
quick check the air tubes, for exact assembly steps - refer to page 4“
How To Fit Air Tube
” )
Check if D9,A2 / D14, A2 are loose,( refer to page 24, step 15 & page 29, step 22 )
43
如果打氣時壓力表指針沒有移到紅色區域,或不確定漏氣位置。
確認空氣軟管是否安裝正確(以下標示區域可幫助您快速確認空氣軟管是否脫落,
組裝步驟請參考第
4
頁
˝
空氣軟管安裝
˝
)
請確認D9/A2及D14/A2是否鬆脫,請參考第24頁─步驟15和第29頁─步驟22。
1-1
1
1-2
D14
D9
A2
A2
Trouble Shooting
簡 易 故 障 排 除
Summary of Contents for GE-631
Page 1: ...Manual Assembly Instruction 組裝說明手冊 GE 631 空氣動力引擎車 Air Engine Car Kit ...
Page 17: ...30 23 24 1 31 25 4 3 2 1 ...
Page 18: ...D6 C4 32 26 27 2 3 2 4 5 1 1 6 1 P19 P19 02 02 比例 1 1 P1x5 33 28 29 Top View 上視圖 Scale 1 1 ...
Page 22: ...1cm B11 40 P18x5 42 43 41 恭喜完成 P19 P19 06 07 44 Finished ...