2) Feeding length: rotate the knob, when "LEN" is displayed in the second column
_
on the left, press the knob to set the feeding length, the adjustment range is
_
0 ~ 99.5mm, and press the knob to save the setting;
3)
Return length: rotate the knob, when "RET" is displayed in the second column
_
on the left, press the knob to set the return length, the adjustment range is
_
0 ~ 19.5mm, and press the knob to save the setting;
4) Interval time: rotate the knob, and when the "INR" is displayed in the second
_
column on the left, press the knob to set the interval time, the adjustment range
_
is 0 ~ 9.5s, and press the knob to save the setting;
5) Feeding speed: rotate the knob, when the "SPD" is displayed in the second
_
on the left, press the knob to set the output speed, with the adjustment range
_
of 1 ~ 40mm / s, and press the knob to save the setting;
6)
Working mode: rotate the knob. When the "MODE" is displayed in the second
_
column on the left, press the knob to enter the working mode. The adjustment
_
range is 0 ~ 9. Press the knob to save the setting;
5.4.4
Temperature calibration:
First to measure the temperature of the soldering iron and record the reading
used by temperature tester. then long press the knob to enter the parameter
setting, select the "CALIB", at SET position input the data which setting tempera
-
ture, and CAL position input the data which test value(reading), and click the knob
to save the setting and exit. (temperature calibration set 2 points,one higher than
350℃,another one lower than 350℃ which can obtain the linearity of a wide
temperature range).
PASSWORD
CALIB
CALIB
SET xxx
CAL xxx
5.4.5
Restore settings:
Long press the knob and rotated to "RESTORE DEFAULT", press the knob again and
the parameters setting will automatically return to the initial state.
RESTORE DEFAULT
SLEEP TIME
RESTORE OK!
5.4.6
Sleep time setting:
Long press the knob and rotate to "SLEEP TIME". Press the knob to enter the sleep
setting, set turn off the sleep mode or sleep time from 1-240min according to
needs ; no operation (foot pedal, handle button) for a long time arrived sleep time
setting, the "SLEEPING" will be displayed on the LCD, the tip temperature is down
to 200℃. turn the knob, touch foot switch or handle button can wake up directly,
and the soldering iron will return to the working set quickly.
RESTORE DEFAULT
SLEEP TIME
SLEEP TIME
XXX MIN
Note:
It will not remember and exit automatically while no operations for 5 seconds of the knob.
5.5 Fuse replacement
When fuse is blown, replace it with the same type of fuse(refer to the picture below).
1) Unplug the power cord from the power receptacle.
2)
The fuse holder is located under the AC power receptacle. Use a slotted (–)
_
screwdriver to open the fuse holder.
3)
Replace the fuse with a new one (Φ 5*20mm 2A).
4) Put the fuse holder back in place.
9
