USING THE REMOTE
P
ROGRAMMING
THE
R
EMOTE
The universal remote can be programmed to control most brands of
remote controllable VCRs, satellite receivers and cable boxes. The
remote is already programmed to control most RCA, GE, and
CA
TVs, VCRs, DVD players, laserdisc players and satellite
receivers.
T
ESTING THE
R
EMOTE
To determine whether the universal remote needs to be programmed,
turn a device ON, such as a VCR, point the remote at the VCR, and
press
the
button. Then press POWER or CH (channel up) or
CH v (channel down) to see if the VCR responds to the remote
commands. If not, the remote needs to be programmed.
U
SING
A
UTOMATIC
C
ODE
S
EARCH
The following instructions can be used to program the remote to
control each of the devices connected to your TV. If you want to exit
the automatic code search without programming any of your devices,
press CLEAR until the LED turns off.
1.
Turn on the device you want to control (VCR, SAT, etc.)
Press and hold the button you want to program
VCR2,
etc.). While holding the device button, press and hold
until the red light on the remote turns on, then release both
buttons. For the AUX button, using code search will not work, you
must use direct entry.
3.
Press and release PLAY, then wait 5 seconds or until the LED stops
flashing.
At this point the remote is searching for the correct code to
program. If, after 5 seconds, the device you want to control does
not turn off, press PLAY again to tell the remote to search the next
set of codes.
Continue pressing PLAY until the device turns off or you have
searched through all of the codes. There are
total sets of codes.
If the device does not turn off after pressing PLAY 20 times, then
the remote cannot control that particular device.
If the device you want to control does turn off:
Press and release REVERSE, then wait 2 seconds. Repeat this
step until the device turns back ON.
2.
To finish, press and hold STOP until the red light on the remote
turns off.
REVERSE PLAY
the remote
