background image

2

1. 

Read these Instructions.

2.

 Keep these Instructions.

3.

 Heed all warnings.

4.

 Follow all instructions.

5.

 Do not use this apparatus near water.

6. 

Clean only with a dry cloth.

7.

Do not block any ventilation openings.   

Install in accordance with the 

manufacturer’s instructions.

8.

 Do not install near any heat sources 

such as radiators, heat registers, stoves, or 

other apparatus (including ampli

ers) that 

produce heat.

9.

  Do  not  defeat  the  safety  purpose  of 

the polarized or grounding - type plug. A 

polarized plug has two blades with one 

wider  than  the  other. A  grounding  type 

plug has two blades and a third grounding 

prong. The wide blade or the third prong 

are  provided  for  your  safety.  When  the 

provided plug does not 

fit

 into your outlet, 

consult an electrician for replacement of 

the obsolete outlet.

10.

  Protect  the  power  cord  from  being 

walked on or pinched particularly at plugs, 

convenience receptacles, and the point 

where they exit from the apparatus.

11.

  Only  use  attachments/accessories 

specified by the manufacture

r.

12.

  Use  only  with  a  cart, 

s t a n d ,   t r i p o d ,   b r a c k e t , 

or  table  specified  by  the 

manufacturer,  or  sold  with 

the apparatus. When a cart 

is used, use caution when moving the cart/

apparatus combination to avoid injury from 

tip-over. 

13

.Unplug this apparatus during lightning 

storms or when unused for long periods of 

time.

14.

 Refer all servicing to 

qualified

 service 

personnel.  Servicing  is  required  when 

the apparatus has been damaged in any 

way, such as power-supply cord or plug 

is  damaged,  liquid  has  been  spilled  or 

objects have fallen into the apparatus, the 

apparatus has been exposed to rain or 

moisture, does not operate normally, or has 

been dropped.

Additional Warnings

 

The apparatus shall not be exposed to 

dripping or splashing and that no objects 

lled with liquids, such as vases, shall be 

placed on apparatus.

 

Main plug is used as disconnect device 

and  it  should  remain  readily  operable 

during intended use. In order to disconnect 

the apparatus from the main completely, 

the main plug should be disconnected from 

the main socket outlet completely.

• 

Battery shall not be exposed to excessive 

heat such as sunshine, fire or the like.

• 

Caution marking is located at the rear or 

bottom of the apparatus.

• 

The marking information is located at the 

rear or bottom of apparatus.

FCC Warnings

This device complies with part 15 0f the 

FCC Rules. Operation is subject to the 

following  two  conditions:  1)  this  device 

may not cause harmful interference, and 2) 

This device must accept any interference 

received, including interference that may 

cause undesired operation.

Warning: 

Changes or 

modifications

 to this 

unit not expressly approved by the party 

responsible for compliance could void the 

user’s authority to operate the equipment.

NOTE:

 This equipment has been tested 

and found to comply with the limits for a 

Class B digital device, pursuant to Part 15 

of the FCC Rules.  

IMPORTANT SAFETY INSTRUCTION

Summary of Contents for PSP288-PL










Reviews: