Page 8
Maintenance Instructions
Change of wheel and all service work may only be done when the main power is switched
off.
Before every grinding:
Please check that:
1. You have read and understood the safety instructions
and all functions
2. The grinding wheel is OK, dust cleaner is connected
and that the motor is running without vibrations.
After grinding:
Lock the emergency button and take away the key.
Clean the machine from dust with a dust-cleaner and
use a dry rag to clean up. Never use oil or grease.
After 1-10 pairs:
Dress the grinding wheel.
After 200-400 pairs:
Time to change the grinding wheel. The number of
pairs/wheel depends on how often you dress the wheel,
type of steel etc.
For best grinding result, use only
balanced ProSharp- grinding wheels, MA70 or CA80.
After 800-1000 pairs:
Check the dressing-tool. The diamond must be pointed
and even for best grinding result.
Use only special-
centered dressing tool NDT1 or NDT3 for exact
dressing and best grinding-result.
After 1000-2000 pairs:
The
driving-belt
should be perfectly stretched.
(In some cases more often)
Check the driving-belt by starting the motor. The belt must
run even and smooth.
In cause of belt-tension:
Take off the belt-shroud and driving belt. Loosen the 2
screws for tensioning. Adjust in very small steps and put
the belt back.
Test run. Put the belt-shroud back.
After 1000-3000 pairs:
Service should be made by an authorized service
(or 1-2 seasons)
technician.
Notice:
This is a technical machine and the operator must take
notice that everything can happen earlier or later, bid
defiance to number of pairs or real time.
Please contact us for support about the machine! info@prosharp.net
