PLX82-EIP-PNC ♦ Communication Gateway
Configuring the PROFINET Controller
EtherNet/IP™ Server to PROFINET Controller
User Manual
ProSoft Technology, Inc.
Page 77 of 154
July 24, 2018
*Set IP Address (new configurations)
Enter the IP address, Subnet mask, and Gateway address of this device and
then click the
S
ET
A
DDRESS
button.
You can also obtain an IP address via DHCP by checking the
Get IP Address via
DHCP
radio button.
*Other Functions
- Signal or Reset the module to factory defaults.
The
Signal
button causes the LED on the selected device to blink. This
allows you to easily identify a specific device among other devices.
The
Reset
to factory defaults button sets the device to back to factory
defaults.
When complete, click
A
PPLY
,
then
OK
to save changes.
Use Configuration of...
You can define whether the configuration for a device is created from scratch or
use an existing configuration.
Creating a new configuration:
1
Uncheck the
U
SE
C
ONFIGURATION OF
checkbox to create a new configuration,
or check
U
SE
C
ONFIGURATION OF
box if an existing configuration will be used.
2
Select the device whose configuration will be used for the selected device.
Setting a New Device Name
1
Uncheck the
U
SE
C
ONFIGURATION OF
box.
2
Click the
S
ET
N
AME
tab.
For PROFINET I/O devices (controller or device)...
1
The current name is displayed in the
Device name
field.
2
Enter a new device name in the
New device name
field.
- If you are setting this device name as a temporary device name, check the
temporary checkbox.
- If you are setting this device name as a permanent change, make sure that
the temporary checkbox is unchecked.
3
Click the
S
ET
N
AME
button. The new device name is now used as the current
device name.
Summary of Contents for PLX82-EIP-PNC
Page 4: ......
