Configuration Commands
RLXIC-SG
♦
Intelligent Cellular
User Manual
RadioLinx Intelligent Cellular Serial Modem for Global GPRS/GSM
ProSoft Technology, Inc.
Page 113 of 136
May 29, 2009
*SMTPFROM=email
Sets the email address from which the SMTP message is being sent.
email=email address
(maximum: 30 characters).
*SMTPPW=pw
Sets the password to use when authenticating the email account (*SMTPFROM)
with the server (*SMTPADDR).
pw= password
Note:
Not required to use SMTP settings but may be required by your cellular carrier.
*SMTPSEND=email[body]
Sends an email to the address specified, followed by the body of the email
message. The email message is terminated and sent by entering a
.
or Ctrl-Z on
an empty line. Cannot be configured with AceManager.
email=email address
body=message
body
*SMTPSTATUS?
Returns the status of the last issued SMTP message (*SMTPSEND). If no status
is available 0 is returned. After the status is read, it is cleared out. The status
codes returned come from the SMTP server to which that the modem sent the
request. Unless the receiving server is not standard, they follow the RFC for
SMTP. Cannot be used with AceManager.
Example:
354 = send in progress
250 = sent ok
*SMTPSUBJ=subject
Allows configuration of the default Subject to use if one is not specified in the
message by providing a "Subject: xxx" line as the initial message line.
subject=message subject
*SMTPUSER=user
The email account username to authenticate with the SMTP server
(*SMTPADDR) for sending email.
user=username
(maximum: 40 characters).
Note:
Not required to use SMTP settings but may be required by your cellular carrier.
Summary of Contents for RLXIC-SG
Page 4: ......
