RLXIC-SG
♦
Intelligent Cellular
Configuring your RLXIC-SG
RadioLinx Intelligent Cellular Serial Modem for Global GPRS/GSM
User Manual
Page 38 of 136
ProSoft Technology, Inc.
May 29, 2009
Tip:
If you have configured the RLXIC-SG for settings different than the defaults for Bits per
Second, Data Bits, Parity, and/or Stop Bits, you will need to use your changed settings.
2
Click
OK.
Connected
1
Type
AT
and press
E
NTER
. You should get a reply of "
OK
" or "
0
".
2
To see what you are typing as you type it, you will need to turn on the echo
and verbose mode. Type
ATE1V1
and press
E
NTER
.
3
If you get a reply of "
OK
", then you entered the command successfully. If you
get a reply of "
0
" or "
ERROR
", try entering the command again.
5.3.1 AT
Commands
When using a terminal application, you will need to manually type in each
command.
For most commands, when you are entering them using a terminal
connection, you will need to preface the command with AT (exceptions are
noted), that is,
ATA
which is listed as
A
.
Some commands have specific parameters while other commands will take
whatever you type.
Required variable parameters are denoted with italicized text, example, D
n
.
The
n
is variable.
Acceptable parameters and/or specific formats are listed with each
command.
Most commands with parameters can be entered with ? to read the current
value (for example,
AT&D?
will respond with "2" if the default has not been
changed).
Summary of Contents for RLXIC-SG
Page 4: ......
