104S
♦
ProLinx Gateway
Configure the Gateway
(Firmware v3.00 and later)
Protocol Manual
ProSoft Technology, Inc.
Page 33 of 157
January 22, 2010
2.5 [M_DP_NA_1
104]
This section defines the monitored dual-point database for the server device
emulated. This information is sourced from the database and is transferred to the
remote client unit. Each point in the database can have one of four possible states,
00 = intermediate, 01 = Point Off, 10 = Point On, and 11 = intermediate).
This section takes the following parameters:
Point
#:
DB
Address:
Group(s):
IV DB Bit
Each point is two bits and the DB address value corresponds to the bit offset in the
gateway memory database. For additional information on how to set these
parameters, see the 104S Tutorial and Reference chapters of this manual.
2.6 [M_ST_NA_1
104]
This section defines the monitored step database for the server device emulated.
This information is sourced from the database and is transferred to the remote client
unit.
This section takes the following parameters:
Point
#:
DB
Address:
Group(s):
IV DB Bit
Each point is one, 8-bit byte and the DB Address value corresponds to the byte
offset in the gateway memory database. For additional information on how to set
these parameters, see the 104S Tutorial and Reference chapters of this manual.
Summary of Contents for ProLinx 104S
Page 4: ......
