C: Learning Codes
To program the remote control for your devices by
teaching the commands from your original remote control
to buttons.
Learning codes Method
Place the front of the original remote with the code being
sent so that it is facing the IR transmitter window on the
RV4700 DTS-ES
remote control.
1
Press corresponding Device button(TV, VCR, SAT, CBL,
CD, DVD or AUX ; except AUD) and the Enter button
on the remote control simultaneously. Indicator (orange)
and Device light will be on.
Note:
The lights for 20 seconds is on to indicate that the remote
control is ready to be programmed. The following steps
must be entered while the lights is on.
2
Press the button on the
RV4700 DTS-ES
universal
remote control that you wish to program. Indicator
(orange) will begin to flash continuously and the Device
light will be OFF for 10 seconds.
3
Within 10 seconds, press the button on the original
remote control that you wish to teach into the
RV4700
DTS-ES
remote control. Indicator (green) flash once, and
then begin to flash in orange again.
4
Within 10 seconds, press the same button on the original
remote control again. Indicator (green) flash twice and
then Indicator (orange) and Device light will be on.
Note:
If the Indicator (Red) flash twice instead Green color, the
programming was not successful. Please, repeat the steps
2~4 again.
Using Your Remote
13
Summary of Contents for RV479 DTS-ES
