Options
RAID Configuration 7 - 17
7
RAID Configuration
If you have included the
optional
RAID (Redundant Array of Independent
Disks) configuration in your purchase option, this will allow you to use your
hard disks in combination with
Striping
(
RAID 0)
or
Mirroring
(
RAID 1)
for fault tolerance and performance.
The following pages provide a basic introduction to setting up the RAID. For
full instructions consult the
FT100Li1_0914
document in Microsoft Word
format on the
Device Drivers & Uti User’s Manual CD-ROM
- Navi-
gate (
Browse..
) to
D:\Drivers\RAID\utility\menu\FT100Li1_0914.doc
.
RAID Level
Description
RAID 0
Identical drives reading and writing data in parallel to increase
performance. RAID 0 implements a striped disk array and the
data is broken into blocks and each block is written to a sepa-
rate disk drive.
RAID 1
Identical drives in a mirrored configuration used to protect data.
Should a drive that is part of a mirrored array fail, the mirrored
drive (which contains identical data) will handle all the data.
When a new replacement drive is installed, data to the new
drive is rebuilt from the mirrored drive to restore fault tolerance.
Table 7 - 1
RAID Description
Summary of Contents for D87P
