Troubleshooting
8 - 14 Operation
8
Operation
Problem
Possible Solution
The system freezes or
the screen goes dark.
The system’s power saving features have timed-out (the screen goes dark). Use the AC
adapter, press the
Fn + F4 (Suspend)
key combination, or press the Power Button if no
LEDs are lit.
The system never goes
into hibernate mode.
Power Options
features are not enabled. Go to the
Windows
Power Options
menu and
enable the features you prefer (see
“Enabling Power Options” on page 3 - 15
). Make
sure you have enabled the Hibernate mode from the control panel.
The Infrared device
doesn’t work.
The
FIR
settings are not configured correctly. See
“Configuring the Infrared Settings
for FIR” on page 3 - 26
.
You may need to change the settings for the infrared device in the
BIOS
(see
“Components Menu” on page 5 - 13
) to enable the FIR setting support.
The Infrared
transceiver is blocked. Make sure nothing is between your system’s Infrared
transceiver and the destination’s transceiver. The Infrared
transceivers operate on a “Line
of Sight”.
Summary of Contents for D87P
