Disassembly
2 - 14 Removing the CCD
2.Disassembly
Removing the CCD
1.
Turn
off
the computer, turn it over to remove the battery (
page 2 - 5
).
2.
Lay the computer down on a flat surface with the top case up forming a 90 degree angle. Carefully remove the
rubber covers
-
and screws
-
.
3.
Run your fingers around the inner frame of the LCD panel to lift at the upper point
as indicated by the arrows,
and slightly push and lift up the inner frame at the middle points
-
as indicated by the arrows, and then run
your fingers around the inner frame at the lower point
as indicated by the arrows (
Figure 9a
).
4.
Remove the LCD front cover
(
Figure 9b
).
1
2
3
4
5
6
7
8
5
b.
a.
9
6
2
1
5
7
8
4
3
9. LCD Front Cover
•
2 Screws
Figure 9
CCD Removal
a. Remove rubber and
screws and then careful-
ly release the inner
frame of the LCD panel
at the points indicated by
the arrows.
b. Remove the LCD front
cover.
Summary of Contents for N850HL
