User Guide
P.11
To exit Cold Weather Mode, do any one of the following actions:
•
Open the hood.
•
Start the engine by remote.
•
Turn the ignition key to the IGNITION ON (RUN) position.
•
Press the
for 1 second and release. The remote will beep once and
will
appear on the display.
•
Press and hold the button until the
icon will disappear on the display.
To verify whether the system is in cold weather mode:
•
The
icon should appear on your remote display.
•
OR
•
Press the brake pedal:
•
If the vehicle is in cold weather mode, the parking lights will remain ON while the brake
pedal
is
pressed.
(Automatic transmission ONLY).
Extended
Run
Time
While the vehicle is running under a remote start, press and hold the button until the remote
plays the start melody. This will reset the run time counter to zero and restart the run time cycle
from the beginning. The extended run time procedure can only be carried out once per
remote start.
To stop the vehicle, at any moment, simply press the button.
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle
has been running for 2 minutes already, pressing the button will reset the counter
to zero and allow the engine to run for another cycle (in this case, 3 minutes).
LED
flashing
To disable the LED: Press and hold
and
simultaneously until the remote beeps once,
pause for 2 seconds, then beeps once again. Release the buttons. The parking light will flash 3
times.
To Enable the LED: Press and hold
and
simultaneously until the remote beeps once,
pause for 2 seconds, then beeps once again. Release the buttons. The parking light will flash 1
time.
Constant
output
•
Pressing and holding the
button for more than 3 seconds will lock all doors and will send a
constant pulse as long as the
button is held down (maximum of 15 seconds). This constant
pulse can be configured to activate certain functionalities such as rolling up the windows –
Please refer to your installer to see if your vehicle is compatible with this option.
•
Pressing and holding the
button for more than 3 seconds will unlock all doors and will send a
constant pulse as long as the button is held down (maximum of 15 seconds). This constant
pulse can be configured to activate certain functionalities such as rolling down the windows –
Please refer to your installer to see if your vehicle is compatible with this option.
