Installation Guide
P.13
11
GRAY (–)
Negative
Door input
This input should be used in vehicles that use a negative-switching Dome Light
circuit. Connect to a wire that tests ground with a door open.
CAUTION! You can only use either the NEGATIVE DOOR INPUT or the
POSITIVE DOOR INPUT wire. It is essential that the Module be connected in
such a way as to allow each one of the Doors to be detected by the remote
starter.
12
YELLOW
(+)
Glow-plug
input
This positive input will monitor the Glow Plug Light in Diesel Mode: it will wait
until the Glow Plug Light goes out to crank the Engine. Connect to the side of the
Glow Plug Light that becomes positive when the Light is on.
Note: In Diesel Mode there is an 18-sec. crank timing delay (or approximately
25-sec. if the run time is set to 30 min.): if the Glow Plug Light is still on after the
delay expires, the module will proceed to start the Engine.
(Also known as the “wait-to-start light”.) The purpose of the Glow-plug circuit
on diesel vehicles is to pre-heat the Combustion Chamber before the vehicle is
started.
When a Remote Starter is installed on a diesel vehicle, the Glow- plug section of
the Ignition circuit must be activated and allowed to operate before the vehicle is
remote-started. For that purpose, the Glow-plug input wire of the module must be
connected to the Glow-plug indicator light of the vehicle. The module will only
accept positive Glow-plug input signals, if the signal is negative, use a relay to
invert its polarity. A diode must be added between the negative Glow-plug trigger
on the relay and the negative Glow-plug wire of the car. This is to prevent
feedback effects on the Glow-plug indicator light on the instrument cluster: the
light on the dash would come on because of the feedback, even though the
circuit is off.
When the user remote-starts the vehicle:
The module will power up the Ignition circuit and wait to engage the Starter Motor
while the Glow-plug indicator light is still on.
The module will engage the Starter Motor as soon as the Glow-plug light (+)
goes out.
Minimum waiting time is 4 seconds.
Maximum waiting time is 30 seconds (approximately).
If no Glow-plug wire is found on the vehicle, the Glow-plug input on the module
may be “timed out”. The module will power up the Ignition and Glow-plug circuits
and simply wait for the time-out before starting.
Keeping the Glow-plug input wire of the module unconnected will hold the
ignition on for the preprogrammed delay.
Warning! Please program the tach before connecting the glow-plug input to the
vehicle.
3-pin Harness
Wire
Description
1
GRAY/ LIGHT
BLUE (–)
AUX 2 Output
Programmable 500mA negative output.
2
BLUE / WHITE
(–)
AUX 1 Output
Programmable 500 mA negative output.
3
YELLOW /
WHITE
(–)
Parking lights
output
500 mA negative Ignition output
