P-22
Installation Guide
Setting the Unit into Ready Mode
If the vehicle has a manual transmission you must read the following indications. The unit must first be set to
Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready Mode, it cannot remote start
the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the option that
was selected. Therefore, you must follow the appropriate procedure between the two described below in order
to set the vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time. The system
will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is pressed, if the parking
brake is disengaged or if the ignition key is turned to the IGNITION ON (RUN) position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
If Ready Mode is enabled by handbrake
1.
Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2.
With the engine already running, apply the
parking brake once and release the brake
pedal.
2.
With the engine already running, apply the
parking brake twice within 10sec.
Make sure to release the brake pedal.
The parking lights will flash 3 times quickly
and remain lit.
Skip to step 4.
3.
Within 20 sec. of engaging the parking
brake, press and hold
, or on
the transmitter.
The parking lights will flash 3 times quickly
and remain lit.
-
4.
Remove the key: the engine will continue running.
5.
Exit the vehicle and close all doors, hood and trunk.
6.
Press for approx. 1 second either:
•
to lock the doors and shut down the engine;
•
to unlock the doors and shut down the engine;
•
to shut down the engine without affecting the doors.
7.
The parking lights will flash 2 times to confirm ready mode activation.
