P-24
Installation Guide
2)
Active Mode:
a)
To arm the Starter Kill, press the
button on the transmitter.
i)
The parking lights will flash once.
ii)
The LED on the antenna will flash slowly.
iii)
If remote door locks are installed, this will also lock the doors and arm the OEM-style alarm.
b)
To disarm the Starter Kill, press the button on the transmitter.
i)
The parking lights will flash twice.
ii)
The LED on the antenna will remain OFF.
iii)
If remote door locks are installed, this will also unlock the doors.
Installation-Programmable Features
The following features can be programmed according to the needs of the installation and the
requirements of the user:
Ignition-Controlled Door Locks
1.
Ignition Lock disabled: turns OFF the Ignition Lock feature.
2.
Ignition Lock enabled: locks all Doors when the key is in the ON position and the user presses the
Brake Pedal. Similarly, when the Ignition key is turned to the OFF position, the Doors will unlock.
3.
Ignition Lock Only: the system will only lock all Doors when the Ignition Key is turned to the IGNITION
ON (RUN) position and Brake Pedal is pressed.
4.
Ignition Unlock Only: the system will unlock all Doors when the Key is turned to the OFF position,
provided the Ignition Key was in the IGNITION ON (RUN) position and the Brake Pedal was pressed at
least once.
Secure Lock
This feature allows the module to control certain OEM factory alarm systems without requiring the use
of other wires for disarming the OEM alarm. (Namely, this feature is designed for OEM systems that
use the factory lock wire to arm the alarm and the unlock wire to disarm it.)
Standard Secure Lock disabled: By default, the unit will send a disarm pulse before IGN, an arm pulse
once the car is remote started and an arm pulse 4 sec after the engine shuts down.
Note: No lock pulse or unlock pulse is sent at any moment of the remote start sequence.
1.
Standard Secure Lock: If this Option is selected,
at remote start, the module will send an
unlock/disarm pulse (disarming the factory Alarm)
before start-up, lock pulse when the
engine is running, and lock/arm pulse 4 seconds after the engine shuts down.
Note: The unit DOES NOT send an arm pulse while the engine is under remote start.
2.
Smart Secure Lock:
i)
If the vehicle was previously locked with the remote starter transmitter, at remote start the
module will send an unlock/disarm pulse before start-up, lock pulse when the engine is
running, and lock/arm pulse 4 seconds after the engine shuts down.
ii)
If the vehicle is initially unlocked, the unit will not send a lock pulse, arm pulse, unlock
pulse or a disarm pulse at any moment of the remote start sequence.
Note: The unit DOES NOT send an arm pulse while the engine is under remote start.
LED Flashing
1.
Enabled without Starter kill: The LED will only flash if IGN is OFF
2.
Disabled: LED flashing is disabled at all times.
3.
Enabled with Starter kill: The LED will only flash when the Starter kill is armed.
