Installation Guide
P.27
Horn Confirmation:
AUX 1 can be programmed to trigger the horn every time the
button is pressed, or when the
button is
pressed twice within 3 seconds. When horn confirmation is activated, panic mode is enabled. If horn
confirmation is disabled, panic mode will not be available.
Negative Accessory Output:
AUX 1 can be programmed as negative Accessory output which is required for certain vehicle models.
Constant Output
1.
Pressing and holding the button for more than 3 seconds will lock all doors and will send a negative
pulse to the lock wire (Brown wire from 12-pin harness) as long as the button is held down
(maximum of 15 seconds). This negative pulse can be configured to activate certain functionalities such
as rolling up the windows.
2.
Pressing and holding the button for more than 3 seconds will unlock all doors and will send a
negative pulse to the unlock wire (Green wire from the 12-pin harness) as long as the button is held
down (maximum of 15 seconds). This negative pulse can be configured to activate certain functionalities
such as rolling down the windows.
AUX 2
Note: This 500 mA negative Aux 2 output can be used for many different applications
Option 1
Constant output (15sec):
1.
If using a two-way LED remote, press and release the AUX button. The button will
stay illuminated.
Or
If using a two-way LCD remote, access LEVEL1.
2.
Press and hold
to activate AUX-2.
Option 2
Toggle ON/OFF for a maximum of 30 seconds:
1.
If using a two-way LED remote, press and release the AUX button. The button will
stay illuminated.
Or
If using a two-way LCD remote, access LEVEL1.
2.
Press and hold
to activate/deactivate AUX-2.
Option 3
Toggle ON/OFF for a maximum of 4 minutes:
1.
If using a two-way LED remote, press and release the AUX button. The button will
stay illuminated.
Or
If using a two-way LCD remote, access LEVEL1.
2.
Press
to activate/de-activate AUX-2. Note that AUX-2 output can ONLY be
activated when the engine is running under a remote start.
Option 4
1.
Negative Starter output: AUX 2 can be programmed as negative Starter output which
is required for certain car models
Or
2.
Negative Clutch Bypass Output: Required on certain manual transmission cars.
