User guide
P.5
WARNING: Engine runs until the pre-programmed run time expires.
6.
The Parking lights will flash twice to indicate Ready mode is set.
Remote
starting
Press the button for approximately 1 second. The parking lights will turn ON to inform you that
the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will
start. The parking lights will remain ON during the pre-programmed run time of the engine.
If your vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Driving
Off
With the vehicle running remotely, press the
button to disarm the starter kill (if installed) and
unlock the doors. Enter the vehicle and do the following:
1.
Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Note: On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will
shut the engine down. Please talk to your technician to determine if the “Takeover mode” can be
set for your vehicle.
Arming
and
disarming
of
the
System
The Alarm can be configured by the installer either to Passive Mode (so as to arm automatically)
or Active Mode (so as to require the user’s intervention for arming). By default, the Remote Car
Starter is configured to Passive Mode.
Passive mode:
To arm the alarm, press the
button on the transmitter, OR
1.
In Passive Mode, the alarm will automatically arm 30sec once the last door is closed.
2.
The LED on the antenna will flash quickly during the countdown preceding the activation
of the system.
3.
Once the activation countdown expires, the siren will chirp once and the LED will flash
slowly to indicate that the alarm is now armed.
To disarm the alarm, press the
button on the transmitter.
1.
The LED on the antenna will flash quickly during the countdown preceding the activation
of the system.
2.
The alarm will automatically rearm itself after 30sec if no door is left opened (if the doors
are monitored) and the ignition is not turned ON.
Active Mode:
To arm the alarm, press the
button on the transmitter.
1.
The siren will chirp once.
2.
The LED on the antenna will flash slowly.
To disarm the Alarm, press the
button on the transmitter.
1.
The siren will chirp twice.
