User guide
P.7
Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of
the run time.
Note2: If the pre-programmed run-time expires or if the user shuts down the engine remotely, the
vehicle will enter Ready Mode automatically (manual transmissions only).
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet
Mode
When the vehicle is in Valet Mode, the remote starter and alarm functionalities are disabled. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from
being remote-started accidentally.
Any of the following features will put the remote car starter into Valet Mode:
Ignition Valet: This feature allows you to set Valet Mode using the ignition key.
Remote valet: This feature allows you to set Valet Mode using the transmitter.
Valet switch: This feature allows you to set Valet Mode using a push button switch (optional).
To put the system into Valet Mode
Using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash 3 times.
2.
Turn the ignition OFF.
3.
The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
Using the TRANSMITTER (Remote Valet Mode):
1.
Press the
and
buttons simultaneously until the siren chirps twice.
2.
The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
Using the PUSH-BUTTON SWITCH (Valet Switch Mode):
1.
Insert the ignition key into the ignition switch.
2.
Turn the key to the ON position
3.
Within 5 seconds, press the push-button switch until the parking lights flash 3 times.
4.
Release the push-button and turn the ignition to the OFF position.
5.
The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
To take the system out of Valet Mode
Using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash twice.
2.
Turn the ignition OFF.
3.
The LED on the antenna will switch OFF indicating that the vehicle is now out of Valet mode.
To take the system out of Valet mode using the TRANSMITTER (Remote Valet Mode):
1.
Press the
and
buttons simultaneously until the siren chirps twice, pauses, then
chirps twice again.
2.
The LED on the antenna will switch OFF indicating that the vehicle is now out of Valet mode.
To take the system out of Valet mode using the PUSH BUTTON SWITCH (Valet Switch
Mode):
1.
Insert the ignition key into the ignition switch.
