P. 18
Installation Guide
Note: For vehicles that require the ignition to be turned ON to activate the brake, follow these
steps:
a.
After flashing the hood, turn the ignition ON; The parking lights will turn OFF
b.
After 4 seconds the parking lights will turn ON and then press the brake.
Entering Programming Options
1)
Enter programming mode (page-17)
the parking lights will stay on for up to 20 seconds.
2)
Before the lights go out, press and hold the brake pedal and then press one of the following
buttons:
i)
------------------------------------------------ ----------- to access mode 1;
ii)
-------------------------------------------- --------------- to access mode 2;
iii)
---------------------------------------------- ------------- to access mode 3;
iv)
-------------------------------------------------------------- to access mode 4.
3)
The siren will chirp once, twice, three or four times to confirm entry into a mode.
4)
Release the brake pedal.
5)
Once the desired mode has been selected, the unit will fall (by default) into function #1 of that
mode; you can now select the option you want in function 1. Once this option has been
chosen, the parking lights will flash one, two, three or four times to confirm your chosen
option. You can not jump over the Function! The unit will move on to function 2 of the
mode selected, and so on.
i)
------------------------------------------------------------ for Option 1,
ii)
------------------------------------------------------------- for Option 2,
iii)
------------------------------------------------------------- for Option 3;
iv)
--------------------------------------------------------------- for Option 4.
Programming Options
Please refer to the Quick Installation Guide for more information on programming options.
Virtual Tach System
Virtual Tach System combines the latest microcontroller technology and a complex algorithm that
took years to develop. VTS is able to effectively monitor the engine starting sequence and release
the starter at the right time without physically connecting the tach wire to the remote starter. The
VTS constantly monitors the data and readjusts itself automatically in order to maximize its
capability to start the engine properly in any weather or deteriorating battery condition
Note: Virtual Tach System is only available in automatic transmission.
Optional Time Delay Adjustment in Virtual Tach System
Follow these steps to program crank time adjustment, if needed:
1.
Enter programming mode (page-17)
the parking lights will stay on for up to 20
seconds.
2.
Before the lights go out, press and hold the brake pedal and press the and
buttons simultaneously
Siren will chirps 4 times. Do not release the brake pedal.
