Before you begin the installation:
The
Configurator App
is needed to configure this
sensor. This App may be downloaded from your mobile
device store.
Select a suitable location for the PSPAC-WFMS sensor. Please
note that the sensor must have good Wi-Fi reception with the
access point it is intended to join. Do not mount in direct sun
or direct rain.
Please have handy the Owner’s Manual for the thermostat that
will be paired with the sensor. thermostats have
unique pairing procedures.
OVERVIEW
This wireless temperature sensor may be used as a room remote temperature sensor (stand alone or averaging) or an
outdoor temperature sensor.
This sensor is compatible with all
Premium, Premium Mini, and Touchscreen thermostats that have been
connected to a Wi-Fi network. Please consult ProStatHVAC.com for a complete listing of compatible thermostats.
Note: This sensor must be connected to the same local network as the thermostat(s) that will use the sensor data.
Configurator
app icon
fig. 1
Unit ID
Legend
fig. 2
To Connect the Sensor to an Access Point:
1.
Remove sensor cover.
2.
Configure the Sensor. (use fig. 2 as a guide)
A
Set the Type:
1. Indoor temperature is sampled and transmitted once every minute.
2. Outdoor temperature is sampled and transmitted once every 5 minutes.
B
Set the Unit ID:
If more than one PSPAC-WFMS is joined to an access point
each sensor must have a unique UNIT ID# to operate properly.
Add all of the ID ’ON’ switches together to arrive at the Unit ID#.
If all the ID number switches are set to ‘OFF’ then the Unit ID# is 0 (zero).
A B
ON
OFF
1 2 4
Example: Unit ID# 5
1 + 4 = 5
USE PHONE CAMERA
FOR MORE INFO
PSPAC-WFMS
Wireless Temperature Sensor
Installation Instructions
