57
MARK68AF1001 Rev 2
14
15
16
Stop the massage if any irregu-
lar noises occur and go to the
Settings option.
Once you are in Settings go the
manual mode.
Individually select each of the
valves. You will hear an au-
dible “click” when you press
the buttons if they are function-
ing correctly. Once you have
all the valves selected hit the
Pump button. If no or little pres-
sure comes out you will need to
prime the pump. Hit Pump one
more time to turn off the unit.
Once the monitor set up is com-
plete, plug in the unit and wait
for the screen to read ‘Touch
to Begin’. Before putting on the
rest of the skirting, it is important
to make sure there is no air in
the zones. Select
‘Full-Body
Massage’
on the home screen
then press
‘Start’.
If any irregular noises come
from the jets or there is low or
no pressure, there is air in the
pump.
Place a towel under the pump
which is located at the food
end of the bed. You will start by
opening 1 of the 3 black plugs
on the pump as shown in the
photo (start on the bottom plug).
Once the first one is is partially
open go back to the manual
mode and hit Pump to start the
unit (make sure the valves are
selected). If this does not re-
solve the problem move onto
the second plug and then the
third.
Checking for air in the zones:
a.
b.
Note: This must be done prior to attaching the remaining
skirts and unit must be filled with water.
