CP - OPTI 12
Operation
English
Automatic replenishment
Depending on the processed amount of films the chemicals are replenished auto-
matically. This is done by pumping chemicals from the replenishment containers.
By means of the film detection switch at the film-infeed, the surface of the proc-
essed films is calculated and after approx. 0.25 m
2
a replenishment cycle is auto-
matically activated for 40 seconds. The replenishment volume per cycle (with pump
set at 100 %) is 150 ml. The table below shows the replenishment volume in
ml per m
2
film surface, dependent on the film width and the pump setting.
*Setting at 50 Hz current resp. settings at 60 Hz current are in brackets
**Standard setting
Rollfilms and Paper Films
Rollfilms can be transported into the machine when a leader film (10x10 cm) is at-
tached, that has been prepared with a chemical resistant adhesive tape.
Replenishment Rate
Film width
Setting of replenishment pump*
100 % (85 %)**
75 % (62 %)
35 cm
600 ml/m
2
450 ml/m
2
24 cm
870 ml/m
2
650 ml/m
2
18 cm
1150 ml/m
2
875 ml/m
2
Rollfilms without leader films and paper should be folded on the corners as per
diagram displayed on the right.
Please note:
High or low room temperature may influence the function of
the film processor machine.
