17
CP - OPTI
Maintenance / Disposal
2.31. Repeat item 2.20 to 2.30 if required (observe information e. g. concerning temperature, time and cleaning pro-
cedure outlined in tank cleaner datasheet)
2.32. Remove roller racks from the machine and remove dirt under flowing water using a soft rag or sponge
2.33. Remove risidual dirt particles from the tanks
2.34. Clean all toothed gear wheels, axles, bearings and rollers, check them for damage (replace if required)
2.35. Remove light protection flap and wipe its underside using a soft rag
2.36. Clean inlet plate using a soft rag
2.37. Reinstall light protection flap
2.38. Align roller racks and re-insert them in machine
2.39. Fill machine with chemicals
2.40. Switch machine on
2.41. Adjust bath temperature to previously adjusted value
2.42. Feed cleaning film (approx. 4 pieces)
2.43. Check function as described under item 1.
2.44. Approx. 15 minutes after reaching of the bath temperature, check it by measuring and recalibrate if required
(see operating instructions page
2
5
)
2.45. Perform sensitometric test
3.
Perform constancy tests based on the applicable national standards (e.g. IEC
61223-2-1 and DIN 6868-2).
Be sure to dipose properly of used machines.
Used machine contain valueable materials that should be recycled
and turned over for proper treatment. Please be sure to turn used
machines over to approved recycling centers.
