11-26
With the crowbar held in this position, rotate the turntable in a clockwise direction by
pressing down on pedal (1) until the tire is completely separated from the wheel rim.
To prevent industrial accidents, keep hands and other parts of the body as far as
possible from the tool arm when the table top is turning.
Remove the inner tube if there is one, need not release the mounting arm,press
down pedal(4),directly tilt the vertical arm.
Repeat the operation for the other tire bead
3). Mounting the Tire
Warning: this checking of tire and rim is of utmost importance to prevent tire
explosion during the inflating operation. Before beginning mounting operation make
sure that:
The tire and the cord fabric are not damaged. If you note the defects, do not mount
the tire.
The rim is without dents and is not warped. Attention with alloy rims, dents because
internal micro-cracks not visible to naked eye. This can compromise the rim and also
be the source of danger especially during inflation.
The diameter of the rim and tire are exactly the same. Never try to mount a tire on a
rim if you cannot identify the diameter of both.
Lubricate the tire beads with the special grease in order to avoid damaging them and
to facilitate the mounting operations.
When tilting the vertical arm, make sure that nobody stands behind the tire
changer.
Summary of Contents for TC-512A
Page 17: ...17 26 13 Electric Connection Diagram...
Page 20: ...20 26...
Page 25: ...25 26...
Page 26: ...26 26...
