9
The measurement process of ALU is the same as that of standard dynamic mode.
After measurement, stick counterweights according to the figure 22 or use a special
purpose gauge to assist in sticking counterweights
.
7.7 ALU1S , ALU2S Modes
ALU1S and ALU2S use automatic gauge to input the accurate size of the correction
plane ( refer to figure 21),The differences between them are:
ALU1S -----stick counterweight on both sides of rim.
ALU2S -----Clamp counterweight inside the rim, and stick counterweight outside
Figure 21
Figure 22
WB-514 Wheel Balancer user’s manual