11
Figure 25
If you can’t enter automatic parameter input interface by pulling Gauge A, Press F3
to enter parameter input interface in ALU1S and ALU2S interfaces. In the parameter
input interface, relative parameters can be modified or input manually. Choose the
parameter to be modified and press key below the screen. For example, to modify
Gauge A parameter, press , a red line appearing in the A value interface
indicates that Gauge A is selected. Press to modify the current value. The
increasing or decreasing range equals the step set by the setting state. (eg. If the
step is 0.5 inch, To press once will increase by 0.5 inch.) While inputting
parameters, press to convert the unit of parameters, like “mm” or “inch”
Input finished. Press to save and return.
7.7.2 ALU1S , ALU2S Mode Operation
After collecting, close the guard, press START to measure. The process is the
same as that of standard dynamic mode.
After measurement, the unbalance is displayed as is shown in figure 26. Rotate
the wheel to the outside correction plane position ,.Because the position is set by the
parameters collected by automatic gauge, the real correction position is not
necessarily at 12 o’clock , in this case, locate the position with the gauge. Stick
counterweight on the outside of rim according to figure 27. ALU1S operations of
WB-514 Wheel Balancer user’s manual