13
7.8 SPLIT Function
Under ALU2, ALU3, ALU1S, ALU2S mode, at the bottom of LCD displays key,
(see figure 28) This function can vector split unbalance weight between the two
spokes on the outside of the wheel so as to hide the counterweights behind the
wheel spokes and the wheel looks beautiful. Operate as follows:
In the interface of figure 28, Press f4 to enter interface of figure 29. Choose the
corresponding wheel according to the actual number of spokes. Press the key
according to the prompt at the bottom of the screen and enter interface of figure 30. If
you want to exit ,press to return to the previous interface.
Take 8 spokes as an example. In the interface of figure 29 Press F6 to choose an 8
–spoke wheel according to the prompt at the bottom of the screen. A red line
surrounding the picture of the corresponding 8-spoke wheel indicates that the wheel
is selected. At the top of the picture appears a mark , Which means that you
can take any spoke as the first and begin to rotate the wheel to 12 o’clock position.
Then press to memorize the point .The system will return to the interface of
figure 28, in which you press to start the motor and make the wheel rotate as
shown in figure 31. When the wheel stops rotating, it automatically enters the
interface of figure 32.
Figure 29
Figure 28
Figure 30
Figure 31
WB-514 Wheel Balancer user’s manual