14
The values on the right of figures 32&33 are two unbalance value after splitting .
Rotate the wheel and stop rotating when the red cursor moves to the middle of the
rule. Stick a counterweight of 51g on the 12 o’clock position. (see figure 32) On the
other 12 o’clock position stick a counterweight of 3g (see figure 33).After the splitting
operation ,Press to exit.
7.9 OPT Function
OPT function is used to determine the best mating of tire and rim. When doing
dynamic and static modes, if the static mode value is greater than OPT value (default
30g), the key will appear on the screen (figure 34) and the system will start
optimization. with the premise of optimization (eg. Inside 7g, outside 44g, static
unbalance value 51g), operate as follows:
In the interface of figure 34,press to enter OPT operation, see figure 35.
Rotate the gas nozzle to 12 o’clock. Press key to memorize the point. Mark
with a chalk a reference mark on the tire.
Figure 32
Figure 33
Figure 34
Figure 35
WB-514 Wheel Balancer user’s manual