20
Pull the gauge to 200mm, press to
memorize the current position and return.
Gauge A calibration finished.
In the interface of figure 47, press to enter
gauge D calibration as shown in figure 50. Hang the
gauge on the rotating shaft of the balancer and
press to memorize the original position and
enter the next item.
Raise the gauge and reach the edge of the rim with
the gauge tip to measure the rim diameter. If it
doesn’t accord with the actual value, modify it by
pressing “+
、
—”.Confirm it and press to
save and return.
Gauge D calibration finished.
Option B scale calibration interface, the
mesurement foot rest to zero at the same time by
check
save button, and then move the
mesurement end to the spindle matcher end at the
same time by check save button and confirm later
put back the mesurement ruler, correction over.
Figure 51
Figure 49
Figure 50
Figure 52
WB-514 Wheel Balancer user’s manual