Chapter 3 Hardware Configuration
SP-7145/7147 SERIES USER MANUAL
Page: 3-5
3.4
Setting Jumpers
You can configure your board by setting the jumpers. A jumper consists of two or
three metal pins with a plastic base mounted on the card. By using a small plastic
"
cap
"
, also known as the jumper cap (with a metal contact inside), you are able to
connect the pins. So you can configure your hardware settings by
"
opening
"
or
"
closing
"
jumpers.
Jumpers can be combined into sets that are called jumper blocks. When jumpers are
all in the block, you have to put them together to set up the hardware configuration.
The figure below shows what this looks like.
Jumpers & Caps
If a jumper has three pins, for example, labeled 1, 2 and 3. You can connect pins 1 and
2 to create one setting and shorting. You can also select to connect pins 2 and 3 to
create another setting. The format of the jumper picture will be illustrated throughout
this manual. The figure below shows different types of jumpers and jumper settings.
Summary of Contents for SP-7145
Page 17: ...Chapter 2 Getting Started SP 7145 7147 SERIES USER MANUAL Page 2 5 Quarter View...
Page 20: ...Chapter 2 Getting Started SP 7145 7147 SERIES USER MANUAL Page 2 8 Quarter View...
Page 109: ...Chapter 5 BIOS Setup SP 7145 7147 SERIES USER MANUAL Page 5 33 BayTrail D...
Page 113: ...Chapter 5 BIOS Setup SP 7145 7147 SERIES USER MANUAL Page 5 37 BayTrail I SoC...
