![background image](http://html1.mh-extra.com/html/proteco/barry/barry_user-manual_1619767012.webp)
9
S3
DS2 DS3 DS4 DS5 DS1
VR1
VR2
VR1- AUTOMATIC CLOSING
VR1 trimmer
sets the automatic closing time (DIP-switch 2 = ON).
The automatic closing time can be adjusted between 1 and 60 seconds.
VR2- FORCE IN OPENING
VR2 trimmer
sets the force and the obstacle detection. Turning the trimmer
clockwise the force increases while the obstacle detection decreases. Calibrate the
obstacle detection force properly, to avoid faults during normal operation. We
recommend to start setting the force to minimum and after adjust step by step
VR3- FORCE IN CLOSING
VR3 trimmer
sets the force and the obstacle detection. Turning the trimmer
clockwise the force increases while the obstacle detection decreases. Calibrate the
obstacle detection force properly, to avoid faults during normal operation. We
recommend to start setting the force to minimum and after adjust step by step
DIP-switch
DIP-switch 1:
ON -
Automatic closing
ACTIVATED
OFF -
Automatic closing
DEACTIVATED
DIP-switch 2:
ON -
The flashing light is
OFF
when the barrier is in stand-by .
OFF -
The flashing light is
ON
when the barrier is in stand-by.
LED Work
OPEN
STOP
CLOSE
LEARN
The barrier is opening
The barrier is in stand-by
The barrier is closing
Transmitter storage in progress
LED Warnings
DS2
DS3
DS4
DS5
DS1
Opening completed
Closing completed
Safety edge / loop detector operating
Photocells calibrated
Barrier powered
TIME
OPEN_FORCE
VR3
CLOSE_FORCE
OPEN STOP CLOSE
LED1
LED2
LED3