Proteco Q80S, Instruction Manual

13 

                                                                                                                                                                                                                                                                                   Q80S_2014

PROTECO S.r.l.

Via Neive, 77 - 12050 Castagnito (CN) ITALY     Tel. +39 0173 210111 - Fax +39 0173 210199      info@proteco.net - www.proteco.net

Deleting ALL stored radio codes

 1  Use          

 buttons to move inside the menu, till the display shows:

  2 

Press and hold button           

for about 10 seconds till the display shows

  3  Release button 

 , 

control unit returns to stand-by

  4  Press button 

 to go back to the top level menus, 

then press button           again till the display shows:

or wait the timeout (20 seconds) to exit

Saving a new radio code for the 2ND RADIO CHANNEL

AUX optional radio module is needed to get a 2nd Radio Channel

  1  Use                            buttons to move inside the menu, till the display shows:

  2  Now 

press and hold

 the

 remote control 

and simultaneously press button

on the control panel. 

The display shows the radio code position

  3  If the display shows 
 

It means that memory is full and no further code can be stored.

  Repeat steps 1) and 2) to save another remote control for the 2ND RADIO CHANNEL

  4  Press button             to go back to the top level menus, 
 

then press button 

  again till the display shows:

or wait the timeout (20 seconds) to exit

(max)

Deleting an existing remote control code

 1  Use                          buttons to move inside the menu, till the display shows:

  2  Press button 

 to confirm 

  3  Use                           buttons to select the position of the code you want to delete

  4 

Press and hold button            

for about 

5 seconds

 till the display shows 

  5  Release button 

 , 

control unit returns to stand-by

  Repeat steps 1) to 5) to delete other existing remote control codes

  6  Press button 

 to go back to the top level menus, 

then press button           again till the display shows:

or wait the timeout (20 seconds) to exit

.......

...